gulliver cot bed ikea Gulliver cot bed ikea

Children Cribs 6 Comments 0 We bought a Ikea Gulliver baby crib and some improvements needed to be made.

bed cot online

We wanted to have the baby on same level as our own bed and without one side. This gave easy access towards the baby during the night. However there was a warning label that prevented that configuration. Reason why this configuration was not allowed was the fact that ends of the bed were not secured well enough to hold the base in place.

  • junior cot bed quilt
  • cot bed duvet sets next
  • cot bed duvet cover and pillowcase
  • That was easy task to solve with couple of zip ties and one nylock nut. Warning label Securing bottom of the bed to the ends. The bolt for the pin was long enough to fit additional nyloc nut to the end and this way it was possible to create good place for the zip tie.

    Instead of nyloc nut, a butterfly nut could be used. If you do not trust to zip ties and you are willing to make additional holes then a L-bracket could be used to secure the ends This is the outcome and this is how the bed was used couple of months before the baby learned how to roll. Then there was a risk that the baby would roll between the beds and fall to the floor. For an engineer that was just one more challenge.

    gulliver cot bed ikea Gulliver cot bed ikea

    Crib on the same level as our bed and without one side The solution for this problem was to secure the beds together.

    I did not want to fix the beds together, but also allow an access between the beds if one want to sit on the bed next to the baby. This was possible with a cabin hooks and extended bolts to the crib. The cabin hooks were screwed under the bed so that you could just fit the hook to the baby crib bolt.

    We are supporting the police and trading standards in their investigation. She was a dainty child but quite strong. This is how we used the crib for first 6 months and when the baby started to crawl the bed base was lowered, but one side was still off for one month.

    Cabin hooks were screwed under the bed. Tip of the hook was slightly bend inwards. The original bolt was replaced with a threaded rod, a washer plate, a normal nut and an allen head sleeve nut.

    The normal nut is not really needed, but I found pre-cut threaded rods that were bit too long. I did not want to cut those shorter so I just added one nut.

    The replacement bolt and the original bolt.

    Now, we've found a lot of different ones - x60, x70 - and with two and three levels for the mattress. She called it Bubby Minnie.

    With this setup the crib was easy to secure to our bed, but it also gave an easy access between the beds. The other cabin hook was secured to the bolt with the rubber band, so it stayed in place when the crib was pivoted. It was just enough to open the hook from the one side.

  • baby cots uk
  • cot bed with mattress tesco
  • lulworth cot bed assembly instructions
  • Easy access between the bed and crib. This is how we used the crib for first 6 months and when the baby started to crawl the bed base was lowered, but one side was still off for one month. Do not modify or attempt this hack unless you know how to ensure its continued safety.

    gulliver cot bed ikea Gulliver cot bed ikea

    Comment

    Voodoozilkree

    at 18:39

    Excuse for that I interfere … At me a similar situation. I invite to discussion.

    Mooguramar

    at 21:12

    Excellent question

    Leave a Comment